Export tracks to soundfiles with mixer processing weirdness

[hififrey]

I was rendering some stems tonight and ran into what I hope is just me.

When I use the Export command with mixer processing in Sawstudio 5.1 the last couple seconds gets cut off. I ensured I didn't have an area marked by mistake as well, all clear. I then tried the export without the mixer processing and it renders fine the entire length. Can anyone else get this to happen?

-Cory

[Grekim]

Probably related to plug-ins you're using with latency. Are you using UAD plug-ins? Would it be simple enough to just extend the marked area?

[Dave Labrecque]

Try putting a blank region a few seconds down the timeline following the end of the audio data. This fixes my UAD-related issues that sound like what you're experiencing. If you're using a marked area, then yes, extend that area past the point where you want the render to end.

[Sean McCoy]

Hmm, virtually all my mixes use UAD plugins on both input and output tracks, and I never have to extend beyond the end unless there's a reverb ringout. What am I doing...wrong? ;)

Edit: Ah, I see this isn't for building mixes but for track exporting with processing, which I rarely do. I'll have to experiment a bit...