PDA

View Full Version : "I" "R" and "O" position in Z mixer



DominicPerry
03-27-2008, 02:29 PM
Bob,

Is it intentional that the position which you see in the Z mixer changes when you click on the I, R and O buttons? .. If I'm looking at the EQ or input sections of the Input channels and click "R" or "O" it takes me to the faders. Is this the same behaviour as SAW?

Dominic

Bob L
03-27-2008, 02:58 PM
The vertical offset position is retained for each section, since these sections are quite different from each other... so if you jump to the Returns and then slide the vertical offset somewhere up the module, this offset will be retained for the next time you jump to the Return section... same for the Outputs.

Bob L

DominicPerry
03-27-2008, 03:07 PM
Understood, thanks, very useful in fact, good call (as usual).

Thanks

Dominic