How many Inputs can I see.

[HapHazzard]

Howdy all,

In SawStudio Full, how many inputs can I see (from the card).

Steve and I have been working with the tour files and I noticed he can only see the first 24 pairs out of the 32 pairs he has in the Digigram card.

In the setup and routing in AVS-ESmonitor, all channels are present and active.

AISO panel shows all pair present too.

Hap

[AudioAstronomer]

24 stereo pairs is correct, for total of 48 i/o

[HapHazzard]

24 stereo pairs is correct, for total of 48 i/o
So I'm unable to see the last 8 pairs of inputs?

[Bob L]

Correct... SAWStudio full can use up to 48 channels.

SAC can use up to 36 stereo pairs for 72 channels.

Bob L

[Naturally Digital]

So I'm unable to see the last 8 pairs of inputs?No, you should be able to 'see' them but you can only assign 24 pairs to outputs. Not sure if that's what you mean but SAW full can access any 24 pairs of ins/outs at the same time.

[HapHazzard]

Correct... SAWStudio full can use up to 48 channels.

SAC can use up to 36 stereo pairs for 72 channels.

Bob L

OK, let me make sure I have this then.

In the pull downs in the Audio Device Setup I have 24 i/o pairs that I can setup for SAW.
I have to make a call to Steve to have him pull down the Aduio Sevice list and see if the rest of the channels can be seen. ( I forgot to look when I was there) This way we can asign those remaining 8 pairs for other things, Keeping in mind that only 24 pairs can be asigned total.


Hap