PDA

View Full Version : SAC and Signal switcher plug



Bud Johnson
09-24-2008, 02:49 PM
Just had a VO session, so it wasn't a big problem, but
The signal switcher plug patched into the FX pre point was emitting signal whether I clicked on it or not.
Monkeyed around with the bus assignment, putting it pre or post, no matter what, it passed talk back??
Probably operator error, but for the life of me, not sure what. ?? SAC 1.2, SS4.4

Bob L
09-24-2008, 03:07 PM
Just tested it here... seemed to work fine... patched pre...

But... one thing to consider is your meter tap point... if you have changed that from Pst to Src, you would see the meter reading even though the sound is not actually passing... perhaps that is what you were running into.

Bob L

Bud Johnson
09-24-2008, 03:09 PM
Probably it. I'll look at it tomorrow.
Thanks
Edit, actually no. It was passing signal as talent and producer over the phone could both hear me without my tapping the switch.