RME Question

[Larry Burger]

I have installed an RME HDSP 9652 card with the new drivers and flash update.
Audio works with Saw Studio 4.4, Saw Studio Lite, SAC 1.0 but it will not work with SAC 1.2.

Any ideas?

[Warren]

I am alos using SAC 1.2 with and RME HDSP9652 no concerns so I don't think its SAC 1.2. Did something change in the OS?

Warren

[Bob L]

My guess is that something is set different in the prefs for SAC 1.2... not sure why though, if you installed it over the old, it should retain the prefs... check and see... perhaps you are set to MME mode instead of ASIO in the new install.

Bob L

[mycorn]

check the clocks...

[HapHazzard]

check the clocks...explain the rest of the setup

1 or 2 cards
Adat to what?
whos the master?

Hap

[Larry Burger]

Hap:

Bob is the master..

There are 2 cards, I tried Unit 1 as master and Auto.
The funny thing is with the same card settings SAW and an install of SAC 1.0 worked without changing any settings.
I did a fresh install and now it works.
(On the SAC 1.0 I redirected the installation directory, so it was not an overlay)

I surely could have missed something but I set the ASIO and the cards setting numerous times and it did not work until the fresh install.

Thank you all for the input.