Thanks for the link. Good stuff.
What do you mean by "wire the patch bay connectors with the correct wiring for the unbalanced equipment"?
I'm not worried about noise getting into unbalanced runs so much, just want to be sure the sound gets through cleanly.
In all typical normaling
You might be able to just leave everything wired as balanced to and from the patchbay then you could use a t-s patch cable to bridge between the devices
jmh Yesterday, 04:06 PMThe Dante Virtual sound card driver may have too much latency to use for monitor mixes (although they do say 4, 6, or 10ms). The question is going to
cgrafx Yesterday, 03:37 PM
Re: OT: mixing unblanced gear in a balanced patch bay
Will depend on the patch bay, but if it's a wire soldered to the back, then you would specifically wire as TS, not TRS. Also you'll need to know if the
cgrafx Yesterday, 11:21 PM