The Front Page

Section Widget
Documentation
Categories Widget (Show All)

Article (4)

CMS (4)

Forums (1)

Insert Images (2)

Promote (1)
Recent Articles

ottokarl

There is no available content written by ottokarl

Recent Article Comments Widget
Recent Blog Posts
Recent Forum Posts

About the TCP-Master/Slave!

Hello Folks!

First time use of the TCP-finesse Master/Slave.
This is...I mean this is sooo aaaamaaaziiing, this opens up to a whole
Göran Nordberg Today, 03:10 AM

Re: OT: mixing unblanced gear in a balanced patch bay

Will depend on the patch bay, but if it's a wire soldered to the back, then you would specifically wire as TS, not TRS. Also you'll need to know if the
cgrafx Yesterday, 11:21 PM

Re: OT: mixing unblanced gear in a balanced patch bay

Thanks for the link. Good stuff.

What do you mean by "wire the patch bay connectors with the correct wiring for the unbalanced equipment"?
Dave Labrecque Yesterday, 11:11 PM

Re: OT: mixing unblanced gear in a balanced patch bay

I'm not worried about noise getting into unbalanced runs so much, just want to be sure the sound gets through cleanly.

In all typical normaling
Dave Labrecque Yesterday, 10:47 PM

Re: OT: mixing unblanced gear in a balanced patch bay

You might be able to just leave everything wired as balanced to and from the patchbay then you could use a t-s patch cable to bridge between the devices
jmh Yesterday, 04:06 PM

Powered by vBulletin® Version 4.2.3
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.

SAWStudio

RML Labs Website

SAC

RML Labs Website

About Us

The SAWStudio and SAC software product lines are created by Bob Lentini and sold and supported by his company RML Labs. You can learn more about RML Labs and Bob by visiting the RML Labs Website.

Search

Advanced Search

Connect With Us