Will depend on the patch bay, but if it's a wire soldered to the back, then you would specifically wire as TS, not TRS. Also you'll need to know if the
cgrafx Yesterday, 11:21 PMThanks for the link. Good stuff.
What do you mean by "wire the patch bay connectors with the correct wiring for the unbalanced equipment"?
I'm not worried about noise getting into unbalanced runs so much, just want to be sure the sound gets through cleanly.
In all typical normaling
You might be able to just leave everything wired as balanced to and from the patchbay then you could use a t-s patch cable to bridge between the devices
jmh Yesterday, 04:06 PM
About the TCP-Master/Slave!
Hello Folks!
Göran Nordberg Today, 03:10 AMFirst time use of the TCP-finesse Master/Slave.
This is...I mean this is sooo aaaamaaaziiing, this opens up to a whole