Close

  • Section Widget

  • Recent Articles

  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    Jamie A

    Re: Output plays 1/2 step down

    Yes... that sounds right.

    This morning I turned off the converters and switched the sample in SAW to 44.1 - this worked.

    Sounds

    Jamie A Today, 07:07 AM Go to last post
    Bob L

    Re: Output plays 1/2 step down

    You must set the rate down to 44.1k when you play the finished files. RME cards can auto switch as long as you are using the internal clock as the master...

    Bob L Yesterday, 09:32 PM Go to last post
    Jamie A

    Output plays 1/2 step down

    Ok, I think this is a sample rate issue, but Iím not having any luck fixing it..

    My ADAs are 48k, my RME cards show 48k, my sample rate

    Jamie A Yesterday, 07:09 PM Go to last post
    UpTilDawn

    Re: 64 bit SAW

    I've been concurring with this opinion, since it first got off topic...

    UpTilDawn 12-15-2018, 01:22 PM Go to last post
    mr_es335

    Re: 64 bit SAW

    Good day,

    I thought that this thread was to be about 64-bt SAW?

    PS: I am not attempting to be "forum police" here

    mr_es335 12-15-2018, 10:49 AM Go to last post