For sale is a used RME RayDAT. Unit comes with the main card, expansion card and the sync cable. This card sat in a PC that was stationary and in a clean studio environment. I'd like to get $400...

For sale is a used RME RayDAT. Unit comes with the main card, expansion card and the sync cable. This card sat in a PC that was stationary and in a clean studio environment. I'd like to get $450...

Internet Explorer is my favorite browser..........to download a better browser.

http://www.howtogeek.com/howto/windows-vista/start-an-application-assigned-to-a-specific-cpu-in-windows-vista/

I have never attempted to actually set affinity using this method but it seems simple...

If you opt to go back to Windows 7 or newer, you can set processor affinity via the target line on the shortcut.

I have used the f90's for about 7 years. They aren't bad mics. They have mostly held up over the years, except with the occasional drummer hits one. However, I don't like the clips. They clip...

I'm not saying that will definitely have problems, but you more than likely will. The bridge chipset usually forces all of the pci slots to one IRQ. which for audio generally spells disaster. YMMV

None of the z87 boards I could find have PCI. However if you find a z87 board with PCI, it is not native. It will use a bridge chip. The use of more than 1 PCI card in those types of systems...

Does windows 8 offer compatibility mode for programs? If so, try that.

In addition, do you have touch screen mode enabled?

Are you looking for a motherboard that currently goes with a processor that you have? I had two of the LE versions of that board that both failed within 30 days of ownership.

Most importantly is...

Doc Severinsen still wants a 120k rig.

As a workaround to restarting sac, you can the port in the options menu that the remotes connect to. default is 12.

My assumption would be as a remote, but who knows. I certainly wouldn't suggest running anything more than service pack 2 on a pc that old.

There is nothing in Bob's recommended tweaks that would cause that problem with a normal working install of xp. What programs in task manager are putting your cpu at 100 percent.

First thing, what operating system does it have? Did you only perform the tweaks bob recommends? Did you do additional tweaks?

I personally find the venue systems very pleasurable to work on. Sure the GUI is clunky, but other than patching, manipulating effect parameters, and setting up scenes, everything can be controlled...

Go to the RME site and make sure the firmware in the card is up to date. Some newer drivers require a firmware update.

I doubt the new ssd is the cause of your problems. Unless it is faulty, in...

The shure antenna distro system I got a few years back came with all rg6 cable. Even the short 3 footers.

Most manufacturers recommend placing the antennas no closer than 4-6 feet to each...

How are your units being clocked. Via internal clock? Is anything plugged into the inputs when you get this chirping noise?

Many of us have also noticed that very short attack times on the channel compressor, also causes distortion.

Setup what output you want to use in sac for solo. Then open total mix, and open the matrix view. At the bottom of the view, is phones. Select the output that you set in sac, and uncheck any other...

Did you accidentally control + click on the master output?

@mojogil. I had a very similar issue this weekend. The promoter decided to plug some beer coolers into my distro, which I didn't know...

Try playing a standard mp3 file in Winamp and see if it will play.

Just the couple milliseconds it takes to convert A/D.

I've had the same issue in the past when hard wired. As it turns out, my router was on its death bed. Replaced the router and VOILA!