how to rest bcf2000 to factory settings

[janneman]

hello all
somehow my bcf2000 is acting strange
it's start with all faders halfway up, from the 1 fader halfway up to the nr 8 fader 1/4 way up.
In SAC now infinty down is allmost halfway up, default (control clickfader) = now way up.
tried several things, but can not find the way to set everything to factory settings.
if this is possible, than I could start over again with dumping the sys-file again.
wich I tried also, with no luck.

greetings
janneman

[janneman]

hello all
I found the answer by gooling the net
this is what I found:

Topic: How do I properly calibrate the range of the faders on my BCF2000?

Solution To initiate the BCF2000's fader calibration routine, begin with the BCF2000 turned OFF.
Press and hold the LEARN button.
While continuing to hold the LEARN button, turn on the power to the BCF2000, then release the LEARN button.
The BCF2000 will go through a brief calibration routine, ensuring that the range of MIDI values sent from the faders corresponds with the actual physical range of motion of the faders.

tried it and now the bcf2000 is reacting as before.

greetings
janneman

[Bob L]

Good info... thanks.

Bob L