Anybody here using or have used ADAT/Toslink feed through panel mount connectors like these?
http://www.switchcraft.com/Product_T...eh_toslink.png (sorry picture is too large to post).
I'm using a pair of them to connect ADAT connections between two preamp racks.
But I'm having trouble with consistent sync at the computer.
I found that if I bypass one feed through and plug one rack out directly from the preamp to the other feed through, then I can establish and keep sync right away.
It's really curious to me that I don't seem to be able to get reliable sync, since I'm only using three 1.5 ft cables and the two interconnects. I've tried another panel connector and two other cables, with no change. As soon as I take one cable and connector out of the configuration, everything is fine.
Does anybody have any ideas on what's causing this issue of not being able to use the second connector and a third cable?
I could sure use some insight, so I might figure out how to solve the problem - other than not using those two things... that defeats the purpose of using the feed through connectors.
Connect With Us