SAC (and Plugins) 64 Bit Version Bug Reports

[Bob L]

Consider putting the RME TotalMix in DAW mode... which is a 1 to 1 routing.

Bob L

[Bruce Callaway]

Consider putting the RME TotalMix in DAW mode... which is a 1 to 1 routing.

Bob L

Good advice. Did that plus uninstalled and reinstalled RME drivers/Totalmix and SAC64 but to no avail. I just get no output from the monitor mixes to any output device, main mix no problem. I must have a Windows issue somewhere, go figure.

[Bob L]

Anyone else having this same issue or is their SAC64 able to output to multiple devices. Mine seems to be working here.

Bob L

[Mike Bizanovich]

Anyone else having this same issue or is their SAC64 able to output to multiple devices. Mine seems to be working here.

Bob L

Bob, Just tested. I have outputs on 8 channels of a Behringer ADA8000

[Bob L]

OK... confirmed, I am able to duplicate the problem with no signal from any of the Monitor mixers... checking further into it now... FOH seems fine to all outputs... Monitor Mixers... no output to any device.

Bob L

[Bruce Callaway]

OK... confirmed, I am able to duplicate the problem with no signal from any of the Monitor mixers... checking further into it now... FOH seems fine to all outputs... Monitor Mixers... no output to any device.

Bob L

I am relieved to learn that Bob, I though I was going insane.

[Steve L]

Same here. Spent hours going back and forth on different "solutions" Nothing. Funny that all the outputs work in FOH main but not on any of the Monitor outputs.
Steven Lewis
Mountain View Recording
Audio-Video Electronics
Richmond, KY