SAC (and Plugins) 64 Bit Version Bug Reports

[Mike Bizanovich]

SAC-Link / SAW-Link
When I hit the SAC-Link button I can go to SAW but when I hit SAC-Link button, I go to the desktop. Both programs are still operational but I must hit the SAW icon on the Taskbar to go to SAW.

[Steve L]

I have the same problem but figured it was another "operator error" thing that I would have to track down. Tried several different setups from scratch and imported
others and still no monitor outputs.
Lenovo laptop C2D 2.8G 8 G DDR3 ram Profire 2626 with one ADA8000
SAC 4.5 is working fine ie all monitors good but SAC64 isn't doing monitors. Mains are OK

Steven Lewis
Mountain View Recording
Audio-Video Electronics

[Steve L]

Update to previous post.
Ok this is strange. I run the mains on 1/2 and the sub on 7/8 of the Profire. Side by side on the Out 1 and Out 2 of the FOH-Main and assigned to 1 and 2 of the output assign section.
They are both working,
but 3/4 5/6 9/10 11/12 are not sending any output to the monitors. It shows a signal on the 3/4 Monitor 1 meters but nothing is going to the monitors.
I can go back and assign the 3/4 as Output 3 on the FOH-Main and it outputs signal to the 3/4 monitor speaker. But resetting it to Monitor 1 and testing
all the assigns does nothing. I'm thinking it has something to do with the Profire but the same exact setup is working in SAC 4.5.

Steven Lewis
Mountain View Recording
Audio-Video Electronics