Close

Results 1 to 3 of 3
  1. #1

    Default Input Selection on Monitormixers

    Hi,
    I've faced a strange behaviour this weekend.
    - In Mon Mixer 2 I've changed the input selection from OFF to PostFdrM
    - Then I've used select 'Copy Input Assignment to All MonMixers'
    - There was not signal arriving at this channels
    - In Mon Mixer 1 the input field shows PST DYN, but the VU indicates no signal
    - When I open the input selection menu, there is nothing marked as assigned.
    - Choosing an option there gets the channel working
    - I assume that the Copy Input Assignment to All MonMixers option does something strange on MonMixer 1, where the selected option is not available.

    Tomy
    3 * TIO1608 + AIC-128 + X-Touch + Dante -> AES + DADC-144DT

    SATlive is my measurement software
    DIN 15905-5 (German SPL Limit)

  2. #2

    Default Re: Input Selection on Monitormixers

    Well... in that situation, you would have to use the copy src to all mon mixers from mon mixer 2 first, then go back to mon mixer 1 to setup the inputs last, since the src selection used in the copy does not exist on mon mixer 1.

    I'll have to look into ignoring changes on mon mixers that don't exist.

    Bob L

  3. #3

    Default Re: Input Selection on Monitormixers

    I'd expect that no changes should occur in this case (which seems to happen now for the inputs of MonMixer1 still assigned).
    Furthermore I'd like a definition of the MonMixer 1 as MonMaster and its treatment as a special mixer (i.e. not affected by 'copy to all monmixers').
    3 * TIO1608 + AIC-128 + X-Touch + Dante -> AES + DADC-144DT

    SATlive is my measurement software
    DIN 15905-5 (German SPL Limit)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •