My system just went haywire on me , U havent used it to record for quite a while but when I started it up I was not getting monitoring in record mode , some ch. would monitor some not so I went into RME Totalmix and it looks totally different now , meters /faders etc. anyhow I cannot get it to work now. I get input signal to the ch. but not to the master out indicators.
1. DO I have to use total mix to monitor ?
2. Is this a RME issue or SAW issue ? ( my old saved setup files are gone , might be else where in my system)
3. how do I test SAW to troubleshoot this ?
Thanks again , major headACHE
Buzz
Connect With Us