Close

  • OT: mixing unblanced gear in a balanced patch bay

    Results 1 to 10 of 18

    Threaded View

    Previous Post Previous Post   Next Post Next Post
    1. 04-22-2024, 10:47 PM #6
      Dave Labrecque's Avatar
      Dave Labrecque
      Dave Labrecque is offline SAWStudio User
      Send a message via Skype™ to Dave Labrecque
      Join Date
      May 2004
      Location
      Becket, Massachusetts
      Posts
      12,556

      Default Re: OT: mixing unblanced gear in a balanced patch bay

      I'm not worried about noise getting into unbalanced runs so much, just want to be sure the sound gets through. These'll be short runs, with the gear close to the bay (I think).

      In all typical normaling scenarios (including half- and double-normals), on the normal-breaking jack, both tip and ring are switched when a plug is inserted.

      Good article (with pictures) at SOS here.
      Last edited by Dave Labrecque; 04-24-2024 at 07:10 AM.
      Dave "it aint the heat, it's the humidity" Labrecque
      Becket, Massachusetts
      Reply With Quote Reply With Quote
    « Previous Thread | Next Thread »

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •  

    Forum Rules