SAC 2.4 (second update) shows graphic M as 00 out 01 etc..
So the first monitor readout seems to all say M00 when they are across Monitors 1 - 5.
SAC 2.4 (second update) shows graphic M as 00 out 01 etc..
So the first monitor readout seems to all say M00 when they are across Monitors 1 - 5.
It appears that you can left click on the label box to select the proper instance of the EQ.
Thanks,
Computer setup 2 and 3 work fine.
I will go back to setup 1, but that rig had all m monitor numbers of 00 even on monitor 1 - 2 -3 -4 etc..
I will re-install late 2.4 and see if thats the problem....
You may just have to close the eq window and change to mixer 1 and double-click the eq to pop open the patch... that may reset the mixer values that may not have been there from an earlier version mix session.
After resetting all patches, then you can resave the session and it should maintain the new mixer values.
Bob L
Thank you....
Connect With Us